S7 PLC HMI

Welcome to the Logo S7 PLC HMI! This program is offering to you the easy control the PLC objects.

The S7 PLC HMI software is Android solutions for PLC Siemens S7 1200, S7 300 and S7 400. You can control via WLAN whole the object as Drive, Valve or Measure.

Siemens S7 1200, 300, 400. To ensure the correct functionalities of S7 -1200, the standard DB compatible with S7 300/400 has to be used. Not optimized DB! And In Protection full access.

S7 PLC HMI Lite
S7 PLC HMI HMI

Email: android@prumsys.cz

Objects:

You can move with table

Binary signal
Signal Address Icon 0 Icon 1
0 Active Inactive
1 Inactive Active
Number
Signed
Unsigned
Drive Running feedback, Error status and command Start and Stop
Status Run Status Error Icon Stop Icon Run Icon Error
0 0 Active Inactive Inactive
1 0 Inactive Active Inactive
X 1 Inactive Inactive Active
When Command Start is set to 1 from HMI, command Stop is set to 0. When Command Stop is set to 1 from HMI, command Start is set to 0.
Drive with Local mode Command can be set, only when Local mode is active!
Drive Running feedback, Error status and command Start and Stop
Status Run Left Status Run Right Status Error Icon Stop Icon Run Left Icon Run Right Icon Error
0 0 0 Active Inactive Inactive Inactive
1 0 0 Inactive Active Inactive Inactive
0 1 0 Inactive Inactive Active Inactive
X X 1 Inactive Inactive Inactive Active
When Command Start is set to 1 from HMI, command Stop is set to 0. When Command Stop is set to 1 from HMI, command Start is set to 0.
Drive with Local mode Command can be set, only when Local mode is active!
Dumper open feedback only, Error status and command open and close
Status Open Status Error Icon Close Icon Open Icon Error
0 0 Active Inactive Inactive
1 0 Inactive Active Inactive
X 1 Inactive Inactive Active
When Command Open is set to 1 from HMI, command Close is set to 0. When Command Close is set to 1 from HMI, command Open is set to 0.
Dumper with Local mode Command can be set, only when Local mode is active!
Valve Close and Open feedback, Error status and command open and close
Status Close Status Open Status Error Icon Close Icon Open Icon Error
0 0 0 Inactive Inactive Active
1 0 0 Active Inactive Inactive
0 1 0 Inactive Active Inactive
X X 1 Inactive Inactive Active
When Command Open is set to 1 from HMI, command Clise is set to 0. When Command Close is set to 1 from HMI, command Open is set to 0.
Drive with Local mode Command can be set, only when Local mode is active!
PLC Config

Object Config

HMI Settings